| quadsource |
Fri Apr 06, 2012 5:06 pm |
|
I rebuilt them both. Upon tunning and re-tunning I noticed one of the mixture screws does nothing when I adjust it. It's above cylinder #2. I also noticed the exhaust pipe on that cylinder is not as hot as the rest. I get a little POP from that velocity stack.
Good compression
New plugs
Wires
Rotor
Cap
I went through the carb twice.
Air passage or something I'm missing?
Thanks.... |
|
| Dale M. |
Fri Apr 06, 2012 6:32 pm |
|
Dirty passage of clogged idle jet.... Pull it out and look at it ...AGAIN...
Dale |
|
| KopfenJager |
Fri Apr 06, 2012 11:16 pm |
|
| plugged idle jet. 99.9% of the time if a carb problem appears, its a idle jet. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|