| bigbulli |
Sun Apr 29, 2012 8:41 am |
|
Trying to,use the jubilee clips that came with the Febi replacement gaiter, but can't find what tool I need to fit them! Any help greatly received.
|
|
| slow36hp |
Sun Apr 29, 2012 9:41 am |
|
|
|
| bigbulli |
Sun Apr 29, 2012 9:48 am |
|
| Many thanks, do I just put it on at tight as possible then crush the square bit? |
|
| slow36hp |
Sun Apr 29, 2012 9:55 am |
|
| yes you click it down as tight as possible then crush the square section. i have a old dull set off end cutters i use |
|
| hazetguy |
Sun Apr 29, 2012 10:01 am |
|
or you can just buy the correct tool that does all the crimping at once.
http://www.shopping.com/K-D-Tools-CV-Boot-Clamp-To...Tools/info |
|
| ToolBox |
Mon Apr 30, 2012 9:19 am |
|
hazetguy wrote: or you can just buy the correct tool that does all the crimping at once.
http://www.shopping.com/K-D-Tools-CV-Boot-Clamp-To...Tools/info
Stop it with that crazy talk of using the correct tool. |
|
| Culito |
Mon Apr 30, 2012 10:53 am |
|
ToolBox wrote: hazetguy wrote: or you can just buy the correct tool that does all the crimping at once.
http://www.shopping.com/K-D-Tools-CV-Boot-Clamp-To...Tools/info
Stop it with that crazy talk of using the correct tool.
:lol:
I always just toss those and use screw clamps. Re-useable! |
|
| IN2RUST |
Mon Apr 30, 2012 12:08 pm |
|
| Yeah, I use an old set of dykes. I have a tool like that, but it seems as though, it would be nice if they made a right angles set for the tough spot. :D |
|
Powered by phpBB © 2001, 2005 phpBB Group
|