| BAS376 |
Sun May 27, 2012 1:51 pm |
|
Hi Volks
You may have seen my earlier posting about repro wings.
My next question is given that no one seems to do repro wings with the round hole cut out (above the bumper mounting slot) for the towel rail bumper support to pass through, it looks like I will have to cut my own but obviously the size and exact location of the hole is critical if the support bar is to fit properly.
Would someone be kind enough to tell me the exact size of the hole and its location when measured say from the top of the bumper slot and in from the edge, on a genuine VW american spec wing - please?
Many thanks
BAS376 |
|
Powered by phpBB © 2001, 2005 phpBB Group
|