TheSamba.com :: View topic

Mon Jun 11, 2012 8:38 am

So A friend installed my new window scrapers from CIP since he was doing the paint he offered I accepted. They came out ok but they were cheaply made even though they said original (I thought German) ANYWAY, My 74 Camper/pop top had the vents on the top part of the window so you can have the windows open and no rain gets in. They are stainless metal (I'll get up pics soon). They did not get re-installed and I'd like to get them back on. Just not sure how they go back on. There are 3 drilled holes in them (the vents) and they are small and I remember small screws holding them on just don't want to put holes where they shouldn't be. And trying to figure out placement as far a the new scrapers already being installed.

Thanks for any insight.

pics added-

vents / autoshade

Mon Jun 11, 2012 2:40 pm

They screw into the metal part of the window scraper, the chrome. They only go on one way, it's near impossible to mess this up.

Mon Jun 11, 2012 4:52 pm

Kinda what I figured -
Just want to be sure they go outside the metal - Since I can't get them under without removing scrapers.

And I thanks ya for the responses.

Mon Jun 11, 2012 6:26 pm

If you have any trouble just let me know, I have them on my Bus and I can snap a couple pics for you.