| Epassetto |
Sat Jun 23, 2012 12:46 pm |
|
so i am planning my winter build and trying to figure out the route i want to go. below is the general idea of what i am wanting so far. it will be a 2165 turbo running e85 and optimized for street/drag strip. the plan is to drive to the drag strip run 11s and then drive home. i understand that i will need tranny work done as well. if you guys have some time to nit pick my build list and help fill in the empty spots it would be greatly appreciated. thanks
Ed Passetto
LONGBLOCK:
2165cc 78.6x94
CB aluminum case
Nickies with JE pistons
CB super race rods
CB Ported street eliminator heads
DPR crank VW journal wedgemated
UNKNOWNS:
Cam
Rockers
Oil pump
Compression ratio
Cylinder head volume
FUELING:
CB high flow dual port end tanks with fuel injector bungs
MK3 vr6 DBC throttle body
VEMS by lugtronics ecu W/ wiring done mil Spec by me (cannon plugs and proper harness protection)
725cc injector dynamics incjectors
-8 AN supply/ -6 AN return lines
IGNITION:
Crank trigger with wastespark coilpack.
TURBO:
Borg warner EFR 6258 (internal WG and DV)
Intercooler
S4 2.7t Auxillary water pump to flow water through turbo and a small radiator
Equal length header that positions turbo alongside cyl 1:2 with V band clamp assembly. |
|
| gprudenciop |
Sun Jun 24, 2012 5:13 pm |
|
| Looks good except for the 8 an feed that is probably to big! Also try to keep your deck height close.as far as cams there are so many different ones and you will get so many different opinions! I am running a motor simular to what you want to build and what i run is a slr xr296 on 112 lobe centers and it runs good . |
|
Powered by phpBB © 2001, 2005 phpBB Group
|