| mrlimbo |
Mon May 05, 2014 2:49 pm |
|
| My 67 bus has a strait clutch lever, but a tranmission I got from a different bus is bent to the right. Any idea what the difference is? Or is it damage? The bent one looks to block the upper bell housing bolt and looks like it will make it more difficult to install the bolt and later adjust the clutch cable. Just curious... I'll probably change them, but I've had bad luck getting them off in the past. Thanks. |
|
| Krustybus |
Mon May 05, 2014 4:01 pm |
|
| I've used both. You're correct about the problems a curved arm causes. I'd go with a straight one if you have a choice. |
|
| BarryL |
Mon May 05, 2014 7:05 pm |
|
mrlimbo wrote: My 67 bus has a strait clutch lever,
'67 came with straight so stick with that. The other one is earlier.
The side cover on a '67 transaxle has a matching angle of the bowden tube bracket to aim better at the straight arm but earlier side covers transaxles still work fine. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|