tumisoft |
Wed May 14, 2014 6:30 am |
|
Hi,
All my turnsignals work ok.
When I pull the hazard switch, only the rear turnsignals flash, no flashing in the front.
I've got a 'normal' relay and am at a loss here.
can anyone help me?
thanks |
|
crofty |
Wed May 14, 2014 7:21 am |
|
Have you doublechecked your wiring? |
|
busdaddy |
Wed May 14, 2014 7:35 am |
|
US spec (combined brake/signal bulb) or European (separate bulb) signals? |
|
tumisoft |
Wed May 14, 2014 8:40 am |
|
US spec, one bulb for brake, turn signal |
|
ToolBox |
Wed May 14, 2014 10:10 am |
|
tumisoft wrote: US spec, one bulb for brake, turn signal
6 Volt or 12 Volt conversion??? |
|
thericklang |
Wed May 14, 2014 5:19 pm |
|
Maybe a bad hazard relay. You may even have 2 hazard relays. For front and rear. My 63 had something like that. |
|
tumisoft |
Thu May 15, 2014 12:11 am |
|
12V conversion
I'll re-check the wiring AND the relay(s) this weekend |
|
ToolBox |
Thu May 15, 2014 9:03 am |
|
tumisoft wrote: 12V conversion
I'll re-check the wiring AND the relay(s) this weekend
If the emergency flasher and/or the emergency relay are 6V they will need to be replaced. |
|
coolerthanelvis |
Thu May 15, 2014 9:49 pm |
|
Your hazard relay, J1 in the diagram, isn't working. It grounds through the mounting clip and doesn't really get a good ground there. It's better to attach a wire to the can and ground it to the body somewhere. |
|
tumisoft |
Fri May 16, 2014 2:56 am |
|
ok, thanks all
i'll check all this and post the result |
|
Powered by phpBB © 2001, 2005 phpBB Group
|