ALLWAGONS |
Thu May 15, 2014 10:19 am |
|
Question for the Gurus,
1. How hard is it to change a wiring harness on an early '62 type 34?
2. Will a dual port engine fit on an early (same car) car bay?
Thanks in advance,
Martin
allwagons |
|
squaretobehip |
Thu May 15, 2014 11:28 am |
|
Martin, where are the pictures? |
|
vwfye |
Thu May 15, 2014 11:44 am |
|
If the bay is like the early notch, you will have to dimple the inner side panels for the carb to fit. I had to do this in my early notch when i put in a 1600 dual carb engine. later, they opened up the bay a bit more for the dual carbs. |
|
ALLWAGONS |
Thu May 15, 2014 11:47 am |
|
squaretobehip wrote: Martin, where are the pictures?
Soon young Jedi! |
|
ibjack |
Thu May 15, 2014 4:46 pm |
|
The wiring harness goes through the rockers so that will be a challenge, it can be done but it will take work. I'm sure you can handle it. Yes a dual carb engine will fit, at least by the looks of this picture.
Pelle has a couple more detailed photos in his gallery. |
|
ALLWAGONS |
Thu May 15, 2014 5:42 pm |
|
Thank You Sir! |
|
Powered by phpBB © 2001, 2005 phpBB Group
|