Wheelie Pete |
Sat May 24, 2014 6:52 pm |
|
I'm just finishing up this RGB build and it looks like the torque spec for the inner driven shaft nut (behind the freeze plug) is 108ft-lbs.
It took a while to find this information - but before I make a mistake,... is that correct??
Thanks!
Wheelie Pete |
|
BarryL |
Sun May 25, 2014 8:36 am |
|
Wheelie Pete wrote: 108ft-lbs.... is that correct?
Yes. Then make sure you knock the little ring that is built into the nut at the place where it will catch one of the slots so it is peened from loosening. |
|
Wheelie Pete |
Sun May 25, 2014 11:59 am |
|
Will do! Thanks for the verification! |
|
Campy |
Wed May 28, 2014 10:05 pm |
|
It is called a "peening" nut. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|