pablovent |
Sat Jun 07, 2014 3:39 pm |
|
Hi guys;
I need replace old seals in the autostick oil pump, but aparently old seals was replaced in the past (not stock position), I have two options:
1.- both new seals with spring inside
2.- both new seals with spring outside
What is correct position??
Apreciate advice, thanks and Regards |
|
jsturtlebuggy |
Sat Jun 07, 2014 6:24 pm |
|
#2 position is correct. You want to keep oil from mixing.
Look at the way a flywheel seal installs, same idea. |
|
pablovent |
Sun Jun 08, 2014 5:22 am |
|
jsturtlebuggy wrote: #2 position is correct. You want to keep oil from mixing.
Look at the way a flywheel seal installs, same idea.
My apologies, edit my post...... picture and option #2, with spring outside (to oil side) like a flywheel seal?...in both the spring should go towards the oil side?, maybe they need lubricate for a long duration... |
|
jsturtlebuggy |
Sun Jun 08, 2014 7:14 am |
|
Yes, you want the spring side of seals facing out on both sides. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|