TheSamba.com Forums
 
  View original topic: Large Flange Fitting
Bloku Thu Jul 03, 2014 8:09 pm

Well I have my large flange header and I would like to buy this stinger that is in not to far away from where I live. here is a picture



And here is my header



I would really like to see if it fits before I buy and ship it (he also said no returns.....). It looks like it is a large 3 flange, but it does not have the same shape, but it still looks close (some shaved off)

Thanks

Dale M. Thu Jul 03, 2014 8:30 pm

Psssst......Tape measure....

OR have him do tracing and email you copy ....

Dale

earthquake Thu Jul 03, 2014 8:50 pm

If the stinger is at a angle you will have to make it will index in the right place, does he have a picture of it that you can see if it will point the right direction?

Casey

Bloku Thu Jul 03, 2014 9:24 pm

Earthquake - If you mean that does it go up at an angle or dose it just go out straight?

earthquake Thu Jul 03, 2014 9:33 pm

Most stinger's I have seen are angled up just a bit so the don't drag on the ground when pulling into a drive way or if your car can pull the front wheels.
there are also stingers for "BobTail" off road systems too but those are angled back quite a bit.

Casey



Powered by phpBB © 2001, 2005 phpBB Group