| scrave |
Mon Aug 04, 2014 4:43 pm |
|
hello, read alot about lowered front ends and such lately but i got a ? i got a 2 inch narrowed beam and want it at stock height cause i putting 2.5 lowered spindles. i thought i read somewhere that the top and bottom springs are adjusted a little different and wondered if any one knew what that might be off hand? i have the adjusters with the interlocking teeth and 2 large nuts.
thanks for any help! |
|
| Joey |
Mon Aug 04, 2014 7:48 pm |
|
| All the stock beams I've seen the torsion arms are parallel to each other when in the relaxed position without the spindle installed. The torsion arms need to be spread apart a bit to install the spindles which would cause a bit of offset or different tension on the torsion leaves. |
|
| scrave |
Mon Aug 04, 2014 8:03 pm |
|
| ok i see now it's already there when you install the spinals, probably shoudla figured that already. that makes sense. thanks so much. ... |
|
Powered by phpBB © 2001, 2005 phpBB Group
|