Beryl Green |
Mon Sep 15, 2014 6:02 pm |
|
Hi, recently noticed my new bus has a few breaks around where the belhousing joins. This leaves a little gap for the 3rd cylinder to peek through. What issues am I looking at and what are some possible fixes. Where I'm at is wanting to get something out of this engine before I rebuild or as the case may be buy new engine. Check it out, any ideas would be appreciated |
|
Glenn |
Mon Sep 15, 2014 6:05 pm |
|
I wouldn't worry about air leaking out. If you're gonna loose sleep over it, get some foil tape to seal it up. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|