| andybla |
Mon Jul 20, 2015 11:14 am |
|
Can somebody tell me where i could find good pictures about the squareback body?
Because my body went off the pan to be sandblasted, but now i cannot seem to get it back together perfectly
The body plate on the rear is not sitting on the rear holes from the chassis and the corners at the back underneath are very strange (you should know this car was allready tempered with by a amateur!)
Is it supposed to be like this? I mean, the cornered lip
|
|
| 1rabbit1981 |
Mon Jul 20, 2015 3:31 pm |
|
Do you have any of the holes lined up? It really should pretty much
just sit down where it is supposed to go.You may have to finesse things a little bit. Dont forget about your body to pan gasket too. |
|
| andybla |
Sun May 15, 2016 2:45 am |
|
Hello,
Can somebody please tell me of the spacing between rear shock towers and body aligns up or is there a slight difference?
I can't seem to get my chassis holes align correctly with the body.
|
|
Powered by phpBB © 2001, 2005 phpBB Group
|