| DON@THEO |
Thu Aug 25, 2016 2:22 pm |
|
Hay Guys
Getting ready to run clutch cable tube in my Railbuggy and have a couple of questions.
As the tube goes over the torsion tube one does it just stick straight back two
how far does it need to stiick out over the torsion tube |
|
| Dale M. |
Thu Aug 25, 2016 3:55 pm |
|
Mount bowden tube first and see where it ends and when placing tube make it a bit long then cut back till you get proper "bow" in bowden tube ...
Dale |
|
| DON@THEO |
Thu Aug 25, 2016 5:30 pm |
|
Sounds good Dale.
On the Bowden tube when I search for it I see a few different ones is the differance only there length. If that is so it wont matter which one I get because i will be adjust the tube to fit right.
also anyone know where I can find the cross bolt in the shift coupler. |
|
| Dale M. |
Thu Aug 25, 2016 7:29 pm |
|
To best of my knowledge length is only difference..
Box style coupler?... Hardware store, any bolt that fits, use nylon lock nut..
Dale |
|
Powered by phpBB © 2001, 2005 phpBB Group
|