| gleep_54 |
Tue Sep 27, 2016 4:34 pm |
|
What is a good break in, ring seating procedure?
Thanks!
Pat |
|
| vwracerdave |
Tue Sep 27, 2016 5:11 pm |
|
| After the initial 20 minute cam break in, oil change and valve adjustment, then drive it like you stole it. You won't seat the rings babying the engine like many people believe you must do the first 500 miles. Drive it like you stole it and the rings will seat quickly. While in 3rd gear floor it to 60 MPH then lift and decelerate to 35 MPH, then stomp it again and repeat a few times. If you made a mistake building it or have a defective part it won't matter if it breaks with 30 miles or 1200 miles on the engine. |
|
| gleep_54 |
Tue Sep 27, 2016 5:20 pm |
|
| Thanks! Had to take the top end back apart to address some things, cam has been run in. Any input on ring gap placement? |
|
| KTPhil |
Tue Sep 27, 2016 5:43 pm |
|
| I've always seen oil gap on top, compression gaps staggered at 8 and 4 o'clock. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|