samotorsport |
Tue Nov 08, 2016 12:31 pm |
|
Hey guys, my gearbox gets out over the winter , the front seal is leaking (the input shaft)
At the same time I take care about the clutch and would like to put in a longer 4 th gear. 0.82 for the moment.
any suggestions what fits ?
What special tools are needed to do the job ?
Best regards
Sam |
|
mcmscott |
Tue Nov 08, 2016 3:14 pm |
|
Fork jig for 091, large pinion nut socket, small pinion nut socket and pinion fixture, side screw socket, misc. snap ring pliers, shop press. |
|
samotorsport |
Tue Nov 08, 2016 4:13 pm |
|
Thanks a lot, I got the press and the pliers
So a lot missing :shock: |
|
Dougy Dee |
Wed Nov 09, 2016 6:25 am |
|
CU code should already have a 0.82 fourth and a 5.43 R&P.
Used in 1600cc buses. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|