harrycrackerdog |
Thu Dec 01, 2016 2:26 pm |
|
Looking for advice
fitting a 2160cc engine on a rebuild of a 59 ghia, and going to order a rancho pro street transmission
so its swing axle and after a bit of research looks like the original gearbox
code 6682312 and the front mount is dated to 59 that I have just took out.
so the rancho box will have later mount ? I have seen adapters that say it will be solid, this worries me about noise etc ?
also do I need the correct nose cone or will this change ?
is there anything else I would need to change ?
thanks in advance
Paul. |
|
ps2375 |
Thu Dec 01, 2016 2:32 pm |
|
Have you asked the place you are getting the tranny from these questions? I'm sure they would know all of those answers, if not, maybe you should look else where. |
|
harrycrackerdog |
Thu Dec 01, 2016 3:07 pm |
|
I didnt want to bombard them with questions and sometimes its difficult over email from UK to USA just looking for advice
thanks |
|
ps2375 |
Thu Dec 01, 2016 3:19 pm |
|
harrycrackerdog wrote: I didnt want to bombard them with questions and sometimes its difficult over email from UK to USA just looking for advice
thanks
That should be part of customer service for a vender here or anywhere. |
|
mcmscott |
Thu Dec 01, 2016 3:50 pm |
|
T-2 nosecone, hockey stick and front mount, then it all bolts in. |
|
txoval |
Thu Dec 01, 2016 3:54 pm |
|
Talk to the vendor. This is common item.
The proper way to address this is to have a bus nose cone and hockey stick installed on the new tranaxle.
This is standard when installing a later model swingaxle in a splitcase car |
|
harrycrackerdog |
Thu Dec 01, 2016 4:09 pm |
|
Thanks guys exactly what I needed
Cheers |
|
jason |
Fri Dec 02, 2016 9:27 am |
|
Tell them what its going in. $75 from them. I just bought one, Erco. |
|
harrycrackerdog |
Sat Dec 10, 2016 3:56 am |
|
ok I ordered the bus nosecone and can anbody tell me what front mount do I use ?
thanks
Paul |
|
Powered by phpBB © 2001, 2005 phpBB Group
|