| NCVDUB |
Fri May 07, 2004 3:39 pm |
|
| How can i lift the back end and the front end on a 1967 Baja bug? |
|
| HamburgerBrad |
Fri May 07, 2004 3:44 pm |
|
search other posts in the forum
front:
cut and turn
adjustable beam
lift spindles
rear:
turn up a spline or two
adjustable spring plates |
|
| HomespunKustom |
Fri May 07, 2004 3:55 pm |
|
| body lift :D |
|
| vwclass11 |
Fri May 07, 2004 4:25 pm |
|
Do you mean like this:
There is another thread on this subject: "Lifts and CVS". I suggest checking it out, Later Mitch. |
|
| HomespunKustom |
Fri May 07, 2004 4:30 pm |
|
| hell yeah!!! thats awesome. the stockish tires need to go!! swampers all the way baby!! |
|
| Nicksan |
Fri May 07, 2004 6:54 pm |
|
brgarris wrote: How can i lift the back end and the front end on a 1967 Baja bug?
You will have to losen up the torsion bar end plates Carefully or you can get hurt bad, Then turn the torsion bars a couple turns on the outside splines only on both sides of the car. The torsion bars have splines on each end of them but a different number on each end. Search for sway away torsion bars for bugs to look at a picture to get an idea. then carefully reassemble. You could also install adjustable spring plates so you can adjust the height and stiffness. |
|
| DanGreen |
Mon May 10, 2004 1:53 am |
|
| check out my thread, almost everything you need to know about lifting the rear, the cheapest way possible that is. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|