| MJMarkham |
Mon Jun 21, 2004 5:39 am |
|
I have a 1200 with a big bore kit (83mm). One of my cylinders is toast. I need to replace just the one, are there any sources for misc. parts like this?
I found a set of 83mm P&Cs for a 1500, will they fit or is the machining where the cylinders mate with the heads and case different?
I need to get this engine going so any advice of leads is greatly appreciated...
Thanks
MJM |
|
| Doppelganger |
Mon Jun 21, 2004 8:22 pm |
|
| I don't know of anybody that will sell a new piston and cylinder. What I do know is that you should replace them as a set. Different compression, wear, weight, make and/or material would cause a lot more trouble than saving yourself a couple of hours by not replacing all four. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|