| stault |
Tue Jul 06, 2004 11:48 am |
|
I'm looking for a vendor that handles galvannealed steel panels in 18 & 20 guage, I was getting it from Eastwood and they are no longer stocking it.
Thanks Steve :( |
|
| keifernet |
Tue Jul 06, 2004 12:46 pm |
|
If your talking about just plain sheets of galvenized metal stock to cut your own panels out of... then try an HVAC company. Most large HVAC companies have a shop they cut/ bend/ fab metal drain pans and duct work/plenums etc in house.
Or look in the yellow pages under Steel supply companies, it is not that hard to find. |
|
| gerg |
Sun Jul 11, 2004 11:08 pm |
|
| Ya, any local industrial supply should be able to help you out. I shop McFadden-Dale here in Vegas and they seem to have everything I need . . . |
|
| Big Jim |
Mon Jul 12, 2004 1:25 am |
|
| The only downside to most industrial suppliers is 1 unit to them is usually a 4 X 10' sheet. It's not all bad because the big piece from them is about the same price as a small patch panel elsewhere. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|