| Cobey |
Fri Jul 23, 2004 5:24 pm |
|
| Any good reason why when I measure out the TDC and advance on the pulley, I should make a notch in it for future use? |
|
| keifernet |
Fri Jul 23, 2004 5:41 pm |
|
| your pulley doesn't already have a notch or some notches in it? |
|
| Cobey |
Fri Jul 23, 2004 6:06 pm |
|
| It has a notch. 5ATDC I think, as I had to find TDC myself and it is roughly 7.6MM from there. |
|
| keifernet |
Fri Jul 23, 2004 6:31 pm |
|
| well sure... once you make sure of your marks you could put a notch in it with a chisel or just use some paint on a q-tip or some fingernail polish, tocuh up paint in a tube whatever you have for future referrence |
|
| Cobey |
Fri Jul 23, 2004 6:43 pm |
|
| Thanks. I was going to use a dremel. :) |
|
Powered by phpBB © 2001, 2005 phpBB Group
|