| Cobey |
Sat Jul 24, 2004 1:13 pm |
|
Hello!
Going through the carb, and came upon this little number and I want to get it sorted out. This is a two peice version. Everything is there, but the connecting hoses have been removed. The port on the carb has been capped, as well that the two ports on the round bit wth the throllte positioner adjusting screw. The two ports on the second piece on the left side of the engine compartment are just disonnected and upcapped.
Is being rid of it as simple as removing the throttle positioner screw and either tying back or removing the positioner arm? Is connecting up simply putting the hoese back in the right place?
TIA! |
|
| Cobey |
Mon Jul 26, 2004 5:50 pm |
|
| Anyone? Hello? Am I the only one with this silly thing installed? |
|
| jhicken |
Mon Jul 26, 2004 7:35 pm |
|
Wish I could help. Only advice I can give is put it back the way it was intended.
-jeffrey |
|
| Cobey |
Mon Jul 26, 2004 7:46 pm |
|
Thanks. I just took a couple of shots in case no one knows what I am talking about.
|
|
Powered by phpBB © 2001, 2005 phpBB Group
|