JoelH |
Tue Nov 02, 2004 10:55 am |
|
http://www2.cip1.com/ProductDetails.asp?ProductCode=VWC%2D115%2D875%2D335%2DB
where do these go? any pictures available????
thanks
Joel |
|
bill may |
Tue Nov 02, 2004 10:58 am |
|
on the front locking mechanism to aluminum channel. were wood on 3 fold tops. wow! wood inside pushrods and wood on ragtop splits"Got Wood?" |
|
JoelH |
Tue Nov 02, 2004 11:05 am |
|
don't quite comprehend. |
|
Bruce |
Tue Nov 02, 2004 12:35 pm |
|
bill may wrote: on the front locking mechanism to aluminum channel. were wood on 3 fold tops.
The ones in my 3 fold are phenolic. Never been rebuilt. |
|
bill may |
Tue Nov 02, 2004 12:42 pm |
|
on the 2 aluminum channels that go front to back on middle groove of aluminum channels of ragtop(you know shiney aluminum seen when ragtop is open) there are nylon/plastic wheels that go in center groove. on forward end of the canvas out side cover there is a 4"?? piece that goes side to side that has 2 screws that let it raise up off body to slide.inside is another piece ,side to side, that has the wheels and this plastic piece(1 each side) that slides on inner edge of aluminum channel shown in link to picture |
|
1961bluebug |
Tue Nov 02, 2004 4:26 pm |
|
sorry for bad pic, but you can see them here:
|
|
Powered by phpBB © 2001, 2005 phpBB Group
|