| Author |
Message |
lt1 kenobi
Samba Member
Joined: March 15, 2008
Posts: 62
|
 Posted: Fri Aug 01, 2008 6:10 pm Post subject: 17x7 raders on slammed 67 |
 |
|
| 2' NARROWED beam stock brakes, drop spindles in front, stock axles in the rear... can I fit the 17x7's on there w/out rubbing in front and rear? Its close to two clicks in the rear and slammed in the front. |
|
| Back to top |
|
 |
luckystiff
Samba Member
Joined: September 28, 2005
Posts: 2252
Location: hickory,nc
|
| Posted: Sat Aug 02, 2008 4:32 pm Post subject: |
|
|
to be"slammed" your probably gonna have to go 4-6" narrowed up front and do a short axle swap out back. most everyone i've seen that was low was no less than 5" narrowed....ken.....
_________________
ITMC
Secret Service |
|
| Back to top |
|
|
Maimas13
Samba Member
Joined: July 06, 2004
Posts: 642
Location: Redwood City CA
|
| Posted: Tue Aug 05, 2008 7:55 pm Post subject: Re: 17x7 raders on slammed 67 |
|
|
| lt1 kenobi wrote: |
| 2' NARROWED beam stock brakes, drop spindles in front, stock axles in the rear... can I fit the 17x7's on there w/out rubbing in front and rear? Its close to two clicks in the rear and slammed in the front. |
"slammed in the front" do you have more than just drop spindles in the front?
I know that 7s will fit in the back no prob... I have 7 inch cookie cutters with 195/60r15s and I have 1/4 inch clearance to the fender, but it never rubs.
but youll def needa go more than 2 inches narrowed, I have 6s up front (on 195s) with just drop spindles and it still rubs every now and then when loaded up
_________________
MAIMAS... read it backwards
(.o\ ! /o.) 62 chopped, dropped, cal looked, oval grafted, 57 styled, ragtop with polk audio sound system, driven daily by an 18 year old
A must read for understanding tires sizes and wheel offsets
Go Bears!!! Mech E |
|
| Back to top |
|
|
|
