Author |
Message |
melvinew2 Samba Member
Joined: December 03, 2011 Posts: 7 Location: ohio circleville
|
Posted: Thu Jul 24, 2014 4:33 pm Post subject: 74 super auto stick wont turn over |
|
|
got the car about 2 month ago put a brand new battery in it would not start hit the started it started and worked find just ever once and a wile it would not start let off the key try to start it again it would start until last night. i had to have some one turn the key wile i hit the starter to get it to start. so i just put a new starter on it to day it started once. now when i turn the key nothing so i got under the car bridged the starter solenoid it started. so i got out my volt meter and it is getting 12.87 at the starter and when i check the volts at the solenoid wire it is only 8.2 when it is hooked to the solenoid and the key turned over. but if i take the wire off the solenoid and have some one turn the key it get 11.5. I am not sure what it could be ? |
|
Back to top |
|
|
Cusser Samba Member
Joined: October 02, 2006 Posts: 31379 Location: Hot Arizona
|
Posted: Thu Jul 24, 2014 4:47 pm Post subject: |
|
|
Am I reading this right (not so easy, by the way) that the voltage under laod is only 8.2? That's low.
Try a jump start from another vehicle. If it starts then, bad battery or bad conenctions at the battery. _________________ 1970 VW (owned since 1972) and 1971 VW Convertible (owned since 1976), second owner of each. The '71 now has the 1835 engine, swapped from the '70. Second owner of each. 1988 Mazda B2200 truck, 1998 Frontier, 2014 Yukon, 2004 Frontier King Cab. All manual transmission except for the Yukon. http://www.thesamba.com/vw/forum/album_page.php?pic_id=335294 http://www.thesamba.com/vw/forum/album_page.php?pic_id=335297 |
|
Back to top |
|
|
melvinew2 Samba Member
Joined: December 03, 2011 Posts: 7 Location: ohio circleville
|
Posted: Thu Jul 24, 2014 4:51 pm Post subject: |
|
|
It will start if i Bridging starter solenoid Its getting well over 12 volts a the big power wire to the starter but only 8 at the little wire going to the solenoid. |
|
Back to top |
|
|
melvinew2 Samba Member
Joined: December 03, 2011 Posts: 7 Location: ohio circleville
|
Posted: Thu Jul 24, 2014 6:00 pm Post subject: |
|
|
switch plug was loose fix it. |
|
Back to top |
|
|
sb001 Samba Member
Joined: May 19, 2011 Posts: 10406 Location: NW Arkansas
|
Posted: Thu Jul 24, 2014 6:29 pm Post subject: |
|
|
melvinew2 wrote: |
switch plug was loose fix it. |
Good, cause I couldn't understand a word of what you were saying. _________________ I'm the humblest guy on this board.
1969 autostick sedan, family owned since new
1600 SP engine
Solex 30 PICT 3 carburetor
Bosch 113905205AE autostick distributor |
|
Back to top |
|
|
peteg59 Samba Member
Joined: December 31, 2009 Posts: 4 Location: NH
|
Posted: Thu Jul 31, 2014 1:26 pm Post subject: |
|
|
I'm basically having the same problem.
What switch wire was loose? |
|
Back to top |
|
|
|