Author |
Message |
dentfreeimage Samba Member
Joined: September 21, 2013 Posts: 292 Location: San Antonio, TX
|
Posted: Sat Aug 01, 2015 9:08 pm Post subject: Valve Adjustment 1.4 Rockers |
|
|
Hello everyone, I just upgraded to 1.4 rockers with lash caps and will like to know what is the recommended valve adjustment. Also I am using chromoly push rods, I use to run .002 with the 1.1 rockers.
I greatly appreciate the advice! |
|
Back to top |
|
|
fivelugshortaxle Samba Member
Joined: May 13, 2011 Posts: 4254 Location: Aumsville, Oregon
|
Posted: Sun Aug 02, 2015 1:32 am Post subject: |
|
|
The rockers have not crap to do with valve adjustments. .006 with aluminum pushrods. Loose zero with chromoly. _________________ Good things come to those who wait.
2332 with lots of goodies....
Rotating assembly balanced by Brothers VW
4340 84mm crank
AA 94mm p&c' s
Total seal 2nd ring, rest are Grants
5.5 h beams
Magnum straight cuts
Steve Long XR310 on a 106
CB 1.4 rockers
CB Magnaspark 2 distributor
NGK D7ea plugs
A1 lowdown 1 3/4 with single muffler
Dellorto 48's with 40 venturies
Kennedy Stage 2 with Daiken disc |
|
Back to top |
|
|
mark tucker Samba Member
Joined: April 08, 2009 Posts: 23937 Location: SHALIMAR ,FLORIDA
|
Posted: Sun Aug 02, 2015 2:34 am Post subject: |
|
|
yes lug they do....... but zero works for most just fine on vw stuff |
|
Back to top |
|
|
dentfreeimage Samba Member
Joined: September 21, 2013 Posts: 292 Location: San Antonio, TX
|
Posted: Sun Aug 02, 2015 6:30 am Post subject: |
|
|
Great, thanks for the help. Just making sure they are no changes by upgrading the rockers. |
|
Back to top |
|
|
dentfreeimage Samba Member
Joined: September 21, 2013 Posts: 292 Location: San Antonio, TX
|
Posted: Sun Aug 02, 2015 6:30 am Post subject: |
|
|
Great, thanks for the help. Just making sure they are no changes by upgrading the rockers. |
|
Back to top |
|
|
mark tucker Samba Member
Joined: April 08, 2009 Posts: 23937 Location: SHALIMAR ,FLORIDA
|
Posted: Sun Aug 02, 2015 9:25 am Post subject: |
|
|
just be sure the geo is close. |
|
Back to top |
|
|
Ebel Samba Member
Joined: June 07, 2015 Posts: 564 Location: New york
|
Posted: Sun Aug 02, 2015 2:12 pm Post subject: |
|
|
Did you change the pushrods at the same time? I'm guessing its a stock cam if your going from 1.1 to 1.4. But I think no matter what you would need shorter pushrods. |
|
Back to top |
|
|
|