Author |
Message |
DrHAX Samba Member
Joined: June 13, 2011 Posts: 247 Location: Isanti MN
|
Posted: Sat Aug 29, 2015 8:29 pm Post subject: Question about linkages. |
|
|
Okay, I've scoured the internet in search for an answer and I've come up with squat. I've gotten my hands on a beat up Porsche Industrial motor shroud I'm convinced, (even if it was in a Porsche its been beat to hell and hacked up, and painted bright canary yellow )
So here's the question guys..
Whats the size of the heim joint for the cross bar? I've tried searching this months now and either I'm entering the wrong terms into search engines, or nobody has posted such trivial information before. (I'm hoping I'm an idiot more the later.)
I plan on using the shroud with some dual carbs, with some knecht aircleaners I got and I want to retain and use the original linkage. Issue is the shroud never came with anything other then the cross bar. So I have the cross bar and I just need to figure out what size the joints are on the cross bar so I can make a system to work with my carbs.
Thank you in advance. _________________ Signed by the rather insane, ambitious, and very stubborn Darko |
|
Back to top |
|
|
Jacks Samba Member
Joined: July 15, 2006 Posts: 2347 Location: San Clemente, Ca.
|
|
Back to top |
|
|
DrHAX Samba Member
Joined: June 13, 2011 Posts: 247 Location: Isanti MN
|
Posted: Sun Aug 30, 2015 12:46 am Post subject: |
|
|
Its sad that in all of my time of searching I couldn't find this stuff
Thank you. _________________ Signed by the rather insane, ambitious, and very stubborn Darko |
|
Back to top |
|
|
|