Author |
Message |
63Fiberbuggy Samba Member
Joined: January 15, 2007 Posts: 217 Location: SC
|
Posted: Mon Nov 30, 2015 12:17 pm Post subject: J-tube center line radius? |
|
|
Anyone know off top of head what the CLR is for J-tube bend? and are they different for SuperFlo Heads vs stock/others?
I need to order a couple U-bends and have new J-tubes fabricated; looking for a spec feed rather than attempt to measure one & screw it up...
Thanks. |
|
Back to top |
|
|
[email protected] Samba Member
Joined: August 03, 2002 Posts: 12785 Location: Salt Lake City, Utah
|
Posted: Mon Nov 30, 2015 1:05 pm Post subject: Re: J-tube center line radius? |
|
|
It depends on what J-tube you are referring to.
Stock heater box?
Header? If so, which one? _________________ It's just advice, do whatever you want with it!
Please do NOT send me Private Messages through the Samba PM System (I will not see them). Send me an e-mail to john at aircooled dot net
"Like" our Facebook page at
http://www.facebook.com/vwpartsaircoolednet
and get a 5% off code for use on one order for VW Parts ON OUR PARTS STORE WEBSITE, vwparts.aircooled.net |
|
Back to top |
|
|
63Fiberbuggy Samba Member
Joined: January 15, 2007 Posts: 217 Location: SC
|
Posted: Tue Dec 01, 2015 4:27 am Post subject: Re: J-tube center line radius? |
|
|
Hey John, thanks for chiming in...it's w/o heater box; came with a used turbo & header I got a while back, then I replaced header with custom one in photo & kept/reused J-tubes (lesson learned, should've replaced both J-tubes at that time). It's 1 5/8" tubing. Pic is best angle I have on my phone. I need to replace tube on right side from head to flange connecting to header. I searched, but didn't find an off the shelf tube that I could shorten leg & weld on flange to connect at header. Thanks again for help...
|
|
Back to top |
|
|
|