Author |
Message |
ldj1002 Samba Member
Joined: August 24, 2015 Posts: 260
|
Posted: Sun Aug 21, 2016 10:16 am Post subject: What is this |
|
|
The thing just above fuel pump and the thing upper left just behind and above accelerator spring
|
|
Back to top |
|
|
GI Joe Samba Member
Joined: April 28, 2005 Posts: 2012 Location: Athens, TN
|
|
Back to top |
|
|
ldj1002 Samba Member
Joined: August 24, 2015 Posts: 260
|
Posted: Sun Aug 21, 2016 11:16 am Post subject: Re: What is this |
|
|
GI Joe wrote: |
Factory 1974 technology, EGR system.... |
This is on a 73 Thing. From my research this engine didn't come in a thing. Anyone know from the # D385814X what this engine is? That tube that goes down to the tin, well on the other side of the tin there is nothing. Would this mean the EGR isn't connected right and if so what can it do to make it right or else just disable the EGR |
|
Back to top |
|
|
GI Joe Samba Member
Joined: April 28, 2005 Posts: 2012 Location: Athens, TN
|
|
Back to top |
|
|
Ron Domeck Samba Member
Joined: August 05, 2007 Posts: 1466 Location: louisville Ky
|
Posted: Sun Aug 21, 2016 3:38 pm Post subject: Re: What is this |
|
|
That tube would have a square metal filter below the sheet metal that would attach to the muffler. The other part you asked about is a dashpot that lets the throttle down slowly. |
|
Back to top |
|
|
ldj1002 Samba Member
Joined: August 24, 2015 Posts: 260
|
Posted: Sun Aug 21, 2016 3:45 pm Post subject: Re: What is this |
|
|
Ron Domeck wrote: |
That tube would have a square metal filter below the sheet metal that would attach to the muffler. The other part you asked about is a dashpot that lets the throttle down slowly. |
Since I don't have the part below the tin does it hurt anything? Should I just leave it as is? |
|
Back to top |
|
|
Ron Domeck Samba Member
Joined: August 05, 2007 Posts: 1466 Location: louisville Ky
|
Posted: Sun Aug 21, 2016 4:13 pm Post subject: Re: What is this |
|
|
It must be plugged already or you would have a leak. Most likely plugged at the carb. Leave it as it is. |
|
Back to top |
|
|
Al Capulco Samba Member
Joined: October 31, 2005 Posts: 532 Location: Northridge, CA.
|
Posted: Sun Aug 21, 2016 6:51 pm Post subject: Re: What is this |
|
|
How's your choke working? |
|
Back to top |
|
|
ldj1002 Samba Member
Joined: August 24, 2015 Posts: 260
|
Posted: Sun Aug 21, 2016 8:01 pm Post subject: Re: What is this |
|
|
Al Capulco wrote: |
How's your choke working? |
It's not. I bought this a couple months ago and have been working on electrical, top, gas tank and other things. Gona start on engine shortly. It ran to put on and off trailer and into shop but it run poorly. At least it didn't smoke or knock and crank thrust is ok so maybe I'll luck out with good engine. |
|
Back to top |
|
|
|