Author |
Message |
project_therapy Samba Member
Joined: September 10, 2006 Posts: 163 Location: san marcos ca
|
Posted: Mon Dec 19, 2016 2:59 pm Post subject: Master cylinder? |
|
|
Can the guru's tell if this is original?
Thank you
|
|
Back to top |
|
|
EverettB Administrator
Joined: April 11, 2000 Posts: 69827 Location: Phoenix Metro
|
|
Back to top |
|
|
Martin Southwell Samba Member
Joined: November 24, 2010 Posts: 986 Location: Bath, England
|
Posted: Mon Dec 19, 2016 5:06 pm Post subject: Re: Master cylinder? |
|
|
I'd agree. Does it have the manufacturers name anywhere, such as ATE? |
|
Back to top |
|
|
project_therapy Samba Member
Joined: September 10, 2006 Posts: 163 Location: san marcos ca
|
Posted: Mon Dec 19, 2016 5:43 pm Post subject: Re: Master cylinder? |
|
|
Thanks guys Ill check but I was wondering the "61" cast marking on top was an indicator of it being a factory part? |
|
Back to top |
|
|
Mr. OGPaint Samba Member
Joined: September 24, 2010 Posts: 823 Location: Oregon
|
Posted: Mon Dec 19, 2016 6:24 pm Post subject: Re: Master cylinder? |
|
|
Is that a 61 or a 19?
My wheel cylinders have the bore size cast onto the exterior, were master cylinders the same? _________________ https://instagram.com/mr.ogpaint
-
Patrick Hall |
|
Back to top |
|
|
splitjunkie Samba Member
Joined: April 04, 2006 Posts: 4095
|
Posted: Mon Dec 19, 2016 7:26 pm Post subject: Re: Master cylinder? |
|
|
Looks correct to me. It's 19 not 61. The bore is 19mm, hence the marking. _________________ Chris
You know, a lot of these scratches will buff right out... Jerry Seinfeld |
|
Back to top |
|
|
project_therapy Samba Member
Joined: September 10, 2006 Posts: 163 Location: san marcos ca
|
Posted: Mon Dec 19, 2016 8:29 pm Post subject: Re: Master cylinder? |
|
|
Thanks everyone.....need to quit reading backwards😀 |
|
Back to top |
|
|
EverettB Administrator
Joined: April 11, 2000 Posts: 69827 Location: Phoenix Metro
|
Posted: Mon Dec 19, 2016 9:50 pm Post subject: Re: Master cylinder? |
|
|
Ultramoron wrote: |
Is that a 61 or a 19?
My wheel cylinders have the bore size cast onto the exterior, were master cylinders the same? |
splitjunkie wrote: |
Looks correct to me. It's 19 not 61. The bore is 19mm, hence the marking. |
Agree, the 19 on the outside is the bore diameter and I have seen that on numerous master cylinders _________________ How to Post Photos
Everett Barnes - [email protected] | My wanted ads
"Water is the only drink for a wise man" | "Communication prevents complaints"
Stop dead photo links! Post your photos to The Samba Gallery! |
|
Back to top |
|
|
|