Author |
Message |
lunatic Samba Member
Joined: July 01, 2005 Posts: 16
|
Posted: Thu Jan 05, 2017 4:19 am Post subject: can anyone give me a measurement...? |
|
|
hi all, could use a bit of a hand. i'm replacing the outer rocker panel on my thing and want to be sure i put the b-pillar back in the correct location/angle. would any of you be so kind as to give me a measurement across the top of your thing from the lip on one middle door pillar to the other so i'm sure to weld it in the correct spot?
i am kicking myself a bit for not tacking a piece across there before starting the cutting, but i didn't realize how much rigidity i would lose.
thanks!
|
|
Back to top |
|
|
GI Joe Samba Member
Joined: April 28, 2005 Posts: 2012 Location: Athens, TN
|
|
Back to top |
|
|
GPthing Samba Member
Joined: January 10, 2007 Posts: 54 Location: Pasadena, CA
|
Posted: Thu Jan 05, 2017 4:53 pm Post subject: Re: can anyone give me a measurement...? |
|
|
Look in the photo gallery (Thing/181) page 124 for measurements.
Brian W
1973 Thing red |
|
Back to top |
|
|
lunatic Samba Member
Joined: July 01, 2005 Posts: 16
|
Posted: Thu Jan 05, 2017 5:18 pm Post subject: Re: can anyone give me a measurement...? |
|
|
thanks guys, exactly what i needed. should have known to go searching first, apologies for that.
now i can continue onward! (done a little bit of work since the first picture)
|
|
Back to top |
|
|
Ron Domeck Samba Member
Joined: August 05, 2007 Posts: 1466 Location: louisville Ky
|
Posted: Thu Jan 05, 2017 8:33 pm Post subject: Re: can anyone give me a measurement...? |
|
|
I would install the doors before welding starting with the front then try to get an even gap all the way around. These door gaps will vary 1/8 to 3/16 in. from car to car. It's not what the factory spec. say but have even gaps. |
|
Back to top |
|
|
Bashr52 Samba Member
Joined: July 16, 2006 Posts: 5666 Location: On an island in VA
|
Posted: Fri Jan 06, 2017 5:34 am Post subject: Re: can anyone give me a measurement...? |
|
|
Ron Domeck wrote: |
I would install the doors before welding starting with the front then try to get an even gap all the way around. These door gaps will vary 1/8 to 3/16 in. from car to car. It's not what the factory spec. say but have even gaps. |
Yep, that's what I did. Put the doors back on to make sure they latched ok and the gap looked uniform. |
|
Back to top |
|
|
lunatic Samba Member
Joined: July 01, 2005 Posts: 16
|
Posted: Fri Jan 06, 2017 7:25 am Post subject: Re: can anyone give me a measurement...? |
|
|
i never removed the b-pillar from the inner rocker, so it should still be in the correct location front to back. just needed the left-to-right measurement so the side didn't look bowed in or bowed out. i imagine i could just do it with a straightedge from a-pillar to c-pillar but wanted to be certain. |
|
Back to top |
|
|
|