Author |
Message |
www2b Samba Member
Joined: September 08, 2010 Posts: 58 Location: Dover
|
Posted: Wed Jan 23, 2013 1:27 pm Post subject: Reverse Pops Out |
|
|
I have a 67 just recently restored. We put in a rebuilt engine. Drove it around a bit then took out the engine and replaced the transmission mounts. We didn't notice they were worn out. Yes, we were out of sequence, kinda learn as we go. Well now it pops out of reverse. Did those mounts have anything to do with this? Also, the shift lever vibrates and rattles, so I looked in the tunnel and there is no shift rod bushing. Could any of this be the cause of the reverse pop out problem? I sure don't want to have to rebuild the transmission. I plan to replace the bushing this weekend. Anything else I should do while I have this apart. Is there a bushing on the other end under the back seat? Thanks |
|
Back to top |
|
|
VOLKSWAGNUT Fastest VW Belt Changer
Joined: October 14, 2007 Posts: 11056 Location: Flippin' a Belt........ .... Off-n-On ... NC USA
|
Posted: Wed Jan 23, 2013 1:46 pm Post subject: |
|
|
Yes, replacing the mounts and getting them tight can change shifter position, so if the shifter is now out of adjustment, it may not be engaging fully...
Replace the shift tube bushing. Be sure you have the retaining spring ring, it will most lilkey be hanging on the shaft so keep an eye out for it as you remove the shift tube. Adjust the shifter when finished. _________________ aka Ken {o\!/o}
Its your vehicle- stop askin' for approval-do what YOU like for cryin' out loud
Better to roll em' how you want and wear em' out-than lettin' em' rot out
Its about the going not the showing
Rebuilt to drive not decorate
WANTED: Local Eatin' Joints, Triple D for TheSamba contributions here http://www.thesamba.com/vw/forum/viewtopic.php?t=570510
Search "VOLKSWAGNUT" on YouTube since you cant watch a "certain" BELT change video round here
Usually and often edited |
|
Back to top |
|
|
www2b Samba Member
Joined: September 08, 2010 Posts: 58 Location: Dover
|
Posted: Sat Jan 26, 2013 7:19 pm Post subject: |
|
|
Well I replaced the bushing today and what a difference that makes. So smooth. But it still pops out of reverse. |
|
Back to top |
|
|
Eric&Barb Samba Member
Joined: September 19, 2004 Posts: 24757 Location: Olympia Wash Rinse & Repeat
|
Posted: Sun Jan 27, 2013 6:25 pm Post subject: |
|
|
Loosen the bolts a bit and try moving the shifter base a little to the front of the Beetle. Retighten the bolts and see if it stays in gear. _________________ In Stereo, Where Available! |
|
Back to top |
|
|
|