Author |
Message |
DWP Samba Member
Joined: September 11, 2007 Posts: 577 Location: Pa.
|
Posted: Thu Jan 29, 2015 6:52 am Post subject: Bus Trans offset info |
|
|
Somehow I got 2 weld in mounts for a bus, 3 rib trans. If you look at the first picture you will see everything lined up the same. But if I flip one over and line up the holes you will see an offset of about 3/8". This shows the offset you need to center the trans FLANGE to FLANGE, not the center of the case.
This way the axles are the same length. I do not have a photo, but the front solid mount plate is offset. make sure you have it the right way.
Just cannot remember if it's to the left or right.
DWP
|
|
Back to top |
|
|
sloboatnova Samba Member
Joined: September 20, 2009 Posts: 989 Location: Broken Arrow, Ok
|
|
Back to top |
|
|
DWP Samba Member
Joined: September 11, 2007 Posts: 577 Location: Pa.
|
Posted: Thu Jan 29, 2015 9:33 am Post subject: |
|
|
I don't about the 10* mount.
On my other bolt on mount I milled out a slot to move it over.
DW |
|
Back to top |
|
|
coptezr92 Samba Member
Joined: January 08, 2015 Posts: 15 Location: TEMECULA
|
Posted: Fri Jan 30, 2015 7:10 am Post subject: |
|
|
On my set up (091) the transaxle is offset 3/8" to the left and my left axel is 3/8" shorter than the right. On my buddies tube car we centered the trans so the axels would be equal length. |
|
Back to top |
|
|
ORANGECRUSHer Samba Member
Joined: June 09, 2006 Posts: 2647 Location: West Coast (Michigan's)
|
Posted: Fri Jan 30, 2015 10:48 am Post subject: |
|
|
Just for $%1ts and grins:
My 091 is so far to the passenger side I expect to have little tranny/horn babies running around the shop someday.
One axle is 1/4" shrter than the other( drivers side I think). I just couldn't shove it over far enough to get equal axles. So I shaved the 1/4" off of one. _________________ Brian H.
I may not know everything,but I will try to help if I can
OrangeCrushER Berrien Warrior 2.4L Quad4
LAZY MARY 1970 Baja 1835cc |
|
Back to top |
|
|
DWP Samba Member
Joined: September 11, 2007 Posts: 577 Location: Pa.
|
Posted: Fri Jan 30, 2015 12:52 pm Post subject: |
|
|
What axles are you running? The 944 Porsche set I have measure 16 1/8 both sides. I centered the trans by measuring Trans flange to wheel flange. Both arms fit with out any problems I would go out and measure but the rail is under the snow.
Coptzer. what axles are you using? |
|
Back to top |
|
|
ORANGECRUSHer Samba Member
Joined: June 09, 2006 Posts: 2647 Location: West Coast (Michigan's)
|
|
Back to top |
|
|
|