oil pump O-ring

Rick Braun · Posted: Tue Jul 07, 2015 5:21 am Post subject: oil pump O-ring

Replacing the gaskets and stock 6mm oil pump. Upon removal, I noticed an O-ring around the section that goes into the case. The new pump (Brazilian)did not come with such an O-ring. Is it supposed to be used? Transfer it? Any advise is appreciated. Thanks

jason · Posted: Tue Jul 07, 2015 5:46 am Post subject:

People sometimes cut a groove and add an oring. Berg adds it too their pumps. If it has a loose fit the oring helps seal. Pain to put in.

Rick Braun · Posted: Wed Jul 08, 2015 4:30 pm Post subject:

No groove cut into the pump - just slid over - it's green, almost looks like a rubber band. Won't be putting it on the new pump. Thanks for replying.


Hello! Log in or Register \| Help \| Donate \| Buy Shirts	See all banner ads \| Advertise on TheSamba.com

	Forum Index -> Split Bus	All times are Mountain Standard Time/Pacific Daylight Savings Time
Page 1 of 1