Author |
Message |
W1K1 Samba Member
Joined: March 04, 2004 Posts: 4921 Location: Southern AB
|
Posted: Sat May 01, 2004 9:39 pm Post subject: Dimension needed ...please help |
|
|
I have to pick up the front of a bus without the beam in it. Can anyone e-mail the dimensions for the four bolt holes that the beam bolts to on the frame? I also need to know what size and length the bolts are as well.
My plan is to cut some plates and drill them to fit, then weld them to a 8ft length of pipe so we can get the front end off the ground with the jacks and back the trailer under it. Unfortunately its a 2 1/2 hour drive to get to the bus in a field, otherwise I would measure and drill the holes there.
My e-mail is [email protected]
thanks in advance to anyone who will help out _________________ http://www.thesamba.com/vw/archives/manuals/jim_martin_engine_build.php
1973 super
1965 squareback 1500E
1971 bay window westy- subi swap |
|
Back to top |
|
|
DubStyle SBS Hit Squad
Joined: July 26, 2003 Posts: 6250 Location: SBS headquarters: Missery
|
Posted: Sun May 02, 2004 3:39 am Post subject: |
|
|
Between the shock towers is 29 9/16 but if you want a little extra space go with 29 5/8" I can't find my drawing with the bolt locations but if your not in a hurry I think I have them at work. _________________ Anthony
SBS #1
SBS #1 on FB
"The original & best lowered Split Bus website/club" |
|
Back to top |
|
|
W1K1 Samba Member
Joined: March 04, 2004 Posts: 4921 Location: Southern AB
|
|
Back to top |
|
|
dstefun Samba Member
Joined: February 20, 2002 Posts: 3338 Location: Sacratomato
|
Posted: Sun May 02, 2004 12:33 pm Post subject: |
|
|
I just posted frame dimensions in another thread .. http://www.thesamba.com/vw/forum/viewtopic.php?p=309338
distance between lower tapped holes shows as 164 mm. _________________ ~~~~~~~~
Radio Questions R Us - what'cha need to know?
"Out! Out! You demons of stupidity!"
Remember - You are required to get older but you are not required to grow up!
62 SC & 66 Bus |
|
Back to top |
|
|
W1K1 Samba Member
Joined: March 04, 2004 Posts: 4921 Location: Southern AB
|
Posted: Wed May 05, 2004 6:50 am Post subject: |
|
|
I have that drawing, I missed that
Anyone know what the bolt size is ?
A pattern of the whole bolt pattern and the distance from the bottom hole to even with the frame would be a big help.
Not any splittys in the area _________________ http://www.thesamba.com/vw/archives/manuals/jim_martin_engine_build.php
1973 super
1965 squareback 1500E
1971 bay window westy- subi swap |
|
Back to top |
|
|
|