Author |
Message |
marklaken Samba Member
Joined: March 19, 2004 Posts: 2416 Location: fort collins, CO
|
Posted: Mon Nov 08, 2004 10:55 am Post subject: seam sealer? POR-15? |
|
|
okay, i am about ready to weld in a new backside driver's rocker panel and have to make about 100 spot welds (1/8" fill-in welds or rossette welds?) from inside the bus to the new backside rockers along the interior floor of the bus...i plan on using SEM aerosol weld through primer (only type my local jobber had..would have prefered 3m brush-on)...
i was wondering if i could use POR-15 instead of seamsealer once my welding is complete? i've never used the POR-15 but i have some on hand...otherwise need to go to the local jobber and pick up seamsealer if that'd be better... any brand that you'd reccomend?
the help is always appreciated, Mark _________________ Wish List:
1967 Wesfalia SO-42 Parts Needed: Kitchenette, Cot Poles
'65 rear left beetle fender
15" Bus Wheels in fair condition
Mark Laken
Fort Collins, CO |
|
Back to top |
|
|
Foxx Uncle Meat
Joined: August 27, 2001 Posts: 4897 Location: at the computer,.......DUH!
|
Posted: Mon Nov 08, 2004 8:41 pm Post subject: |
|
|
as long as the seams are tight,i don't see why not.
i've never had the pleasure of trying it,
but it should work as POR is pretty
much bullet proof _________________ Frank
OG JHC
59 panel
Sarcasm is the body's natural defense against stupidity. i seem to use a lot. |
|
Back to top |
|
|
|