|
|
|
| >Help >Donate >Buy Shirts >Register >Log in | See all Samba banner ads | Advertise on TheSamba.com |
|
||||||
Everett's
1966 Type 34 Log
Main page
| < Prev - Log | Log | Log - Next >
| December 31, 2003 | • Made and test-fit new horn block-off seal | |||
| December 30, 2003 |
• Installed new driver's outer door seal • Reinstalled driver's door panel and misc. parts |
|||
| December 28, 2003 |
• Installed new fuse box |
|||
| December 24, 2003 | • Fill-primed new horn block-off plate | |||
| December 21, 2003 |
• Finished plastic install on driver's door • Installed missing inner door handle foam and arm rest mount pad • Completed clean up of driver's door jam 
 • Cleaned up new fuse box for install 
 • Stripped and epoxy primer new horn block-off plate  |
|||
| December 20, 2003 |
• Installed new paper backing on driver's door panel
 • Installed new plastic on driver's door • Installed new driver's and passenger arm rests  • Started cleaning up driver's outer door seal area |
|||
| December 6, 2003 |
• Picked up my NOS taillight to replace my dented one • Located a possible replacement for my passenger window regulator • Located a nicer horn block off plate. Now I just need some sort of seal... • Finally located a "correct" replacement fuse box. I think these are Type 34 only as I ended up getting it from another Type 34. |
|||
| December 4, 2003 |
• Adjust passenger window stop position • Ordered a bunch of Type 34 seals from KGP&R |
|||
| November 30, 2003 |
• Glued in front hood seal • Adjust passenger window track • Cleaned up passenger door seal area to prepare for new seal
|
|||
| November 23, 2003 |
• Installed driver's quarter window • Installed NOS driver's door latch 
 • Tore down passenger door, installed new hinges and check strap 
 
 • Re-greased passenger door window channels, window winder, and door latch  • Adjusted door latches |
|||
| November 22, 2003 |
• Reassembled and mounted driver's window scraper • Remounted driver's door • Installed new front trunk seal 
 • Installed new front trunk seal latch guard  |
|||
| November 21, 2003 |
• Drilled out rivets and disassembled driver's window scraper • Installed new door hinges onto driver's door |
|||
| November 20, 2003 |
• Repainted driver's side window scraper backing, damaged scraper seal
trying to reinstall quarter window • Re-glued some loose pieces of trim in the rear trunk • Re-glued driver's door pocket to door panel |
|||
| November 19, 2003 |
• Installed new rear trunk light on/off switch plug, installed new trunk
light bulb, cleaned up trunk light dipswitch so it works nicely • Installed new rear trunk hinge plugs 
 • Cleaned up driver's quarter window frame |
|||
| November 18, 2003 | • Cleaned up driver's window scraper | |||
| November 17, 2003 |
• Troubleshot carburetors again, turned out the condenser wire was loose.
Problem solved. • Stripped down driver's door further - Removed quarter window and window scraper |
|||
| November 16, 2003 |
• Removed and stripped down driver's door • Re-greased driver's window track • Cleaned up new driver's arm rest for install • Assembled new driver's door check strap & pins • Removed driver's door latch, attempted to repair. Too loose, will install NOS unit • Reinstalled driver's carburetor - car still running rough |
|||
| November 15, 2003 |
• Painted new door hinges Arcona White • Removed old front hood seal and cleaned up seal area 
 • Disassembled and cleaned both carburetors - they had some dust in them • Noticed passenger side carburetor choke arm was apart - horseshoe clip MIA. Replaced clip with spare • Driver's side carburetor not pumping fuel - problem traced to sticky internal check valve. Removed press fittings. Cleaned passages and check valves. Replaced accelerator pump diaphragm |
|||
| November 14, 2003 |
• Epoxy-primed new door hinges • Loosened driver's side door hinges • Received new door check straps, pins, and front hood seal from KGP&R 
 |
|||
| November 4, 2003 |
• Car hesitating a little, changed out the fuel filter which had some crap in it • Noticed passenger side axle boot leaking a little, tightened clamp |
|||
| October 31, 2003 | • Registered 1966 AZ plates to the car, thanks to Yancy for the '66 plate lead | |||
| October 27, 2003 | • Received new front windshield/turn signal/taillight/headlight/bumper bracket seals in the mail from the Type 34 Thailand connection | |||
| October 24, 2003 | • Received rebuilt door hinges |
