| November
19, 2002 |
• Adjusted rear seat heater outlet cables so vents close completely.
|
| November
17, 2002 |
• Adjusted pedal stop plate, set brake and clutch pedals to correct clearances.
• Re-glued loose drivers foot well carpeting.
• Lubricated squeaky rear suspension. Ahhhh, the nice, quiet ride is back.
|
| November
14, 2002 |
|
• Replaced popout hinge seals, the passenger side was rattling
sometimes:
|
There was some tape on the hinge mounts from an older
fix(?). I removed it
| 
Old rubber seal
| 
New seals I made from 1.5 inch shrink tubing. Shrunk to
fit by hand, then slid on the hinges
|
|
| November
9-10, 2002 |
• Repaired a few more door panels, installed new rubber grommets:
|
| November
7, 2002 |
• Removed rear hatch door panel to fix material
• Repaired loose driver's door panel material
|
| October
27, 2002 |
• Checked
and adjusted chokes for "winter".
• Installed new rear mat
|
| October
8, 2002 |
• Began
soaking my new rear mat in Glycerin to make it more supple
|
| October
4, 2002 |
• Located a
nice used rear mat!
|
|
September 17, 2002 |
• Idling a
little high, adjusted right side linkage as it was a little bit off
|
|
September 14-15, 2002 |
• Replaced
intake manifold seals with correct Type 3 fiber ones, no more metal
• Installed new 12v electromagnetic shutoff valves I got from RMMW,
retuned as needed
• Adjusted front bumper so it was even left to right
|
|
September 7, 2002 |
•
Right side carb. intake sleeve was leaking, sealed it with Loctite #64000
•
Fuel pump was dirty and leaking grease, cleaned it up and resealed it
|
August 30
to
September 2, 2002 |
•
Removed right side engine tin to check for thermostat spring, it was
missing, as suspected, installed new spring.
•
Removed left side engine tin to check for oil cooler sealing foam, it was
missing, as suspected, installed new foam
•
Installed new oil cooler seals
•
Installed new accelerator cable seal
•
Installed new generator brushes
•
Rebuilt carbs., retuned engine
|
Everett's 1967 Squareback Log
