058 nut location marked.jpg
059 nut welded puller installed.jpg
060 pulling plug out.jpg
061 plug out still on puller.jpg
061a plug removed and welds ground off.jpg
061b inside of loose plug.jpg
062 looking in plug hole in box.jpg
065 removing inner nut inside view.jpg
066 removing inner nut with tool.jpg
067 bad inner nut.jpg
068 lug nut comparison.jpg
069 puller on drum.jpg
070 clip for e brake cable.jpg
071 drum and brakes off.jpg
071a tapping bearing cover side.jpg
071b prying bearing cover off.jpg
071c gaskets under bearing cover and wrong seal.jpg
072 backing plate off.jpg
072a tapping cover off.jpg
073 outer box cover is first removed.jpg
073a prying upper outer bearing.jpg
074 upper gear off lower axle still in.jpg
074a tapping out lower axle.jpg
075a lockring of lower bearing closeup.jpg
076 puller on upper inner.jpg
077 pulling upper inner off.jpg
078 all bearings out.jpg
086 remove 6 cover nuts.jpg
087 cover off what you should see.jpg
088 closeup of lockring installed.jpg
089 lockring out with pliers.jpg
090 spacer ring out.jpg
091 pulling gear out with axle still in.jpg
091a pulling out gear with hand.jpg
092 bad axles and fulcrum.jpg
097 pressing bearing off.jpg
098 pressing bearing off.jpg
099 spacers.jpg
099a bent parts.jpg
099b parts.jpg
100 ready for bearings.jpg
101 pressing bearing on axle note spacer.jpg
102 driving inner bearings in.jpg
103 inner bearings installed and clip for lower.jpg
104 driving lower axle in.jpg
105 inner nut on ready for torqueing.jpg
106 nut torqued and peened.jpg
107 plug tapped in and sealed.jpg
108 axle plastic and paper gaskets installed.jpg
109 ready for upper bearing to be installed.jpg
110 upper bearing started.jpg
111 using tool to seat bearing on axle.jpg
112 correct bearing seating groove for circlip exposed.jpg
113 circlip installed properly.jpg
114 gasket installed with sealant tapping on outer cover.jpg
114a tapping outer race.jpg
115 bolts installed for outer housing.jpg
