Additional Photos Click to load image
L & R arrow keys scroll through photos
RJE WBX Lifter bushings to BUG lifters Price: $128 set of 8
I make the bushings so you can put a bug lifter in a waterboxer block . You will have ream or hone the inside of the bushings to fit your lifters. The O.D. of the bushings will need to be de-burred at the oil holes. When you get ready to install you have remember that you are going to use the bug mushroom headed lifters and you will need to remove some of the top of the aluminum WBX lifter bores before you install the bushings. I take off about .200 or 5mm from the stock top of the bores that will get you in the ball park. One way to double check is to measure a stock bug case to the WBX block this will give you numbers to start from. I measure from the cam saddle to the top of the lifter bore on both blocks the difference is the amount you will need to remove from the WBX block. Hope this helps in installing the bushings. Be sure to freeze the bushings before installing them. And be sure to de-burr the outside edges of the bushings and get the oil holes lined up before driving the bushings in. 2nd picture is of the bushings installed and honed to size. shipped USA. Out of the USA please email me on shipping charges. (I do not have instructions on how to install the bushings.) I do not sell the tooling to install the bushings! paypal & email is [email protected] Thanks & check out my other ads. Thanks Rocky