heiko910 Samba Member
Joined: November 15, 2013 Photos: 38 Location: Gardnerville, NV
|
Rocker arm ground down with bench grinder |
Posted: Thu Dec 24, 2015 5:11 pm Views: 64
Rating: Not rated
|
|
In preparation for swivel foot adjusters install. These are type 4 rocker arms with 10mm thread.10mm swivel foot adjusters from Germany are going to be used. The thickness of the rocker arm was reduced from approximately 13mm to 11.5mm by use of a bench grinder and then deburred with a flapper wheel on a dremel. Next step is going to be light counter sinking. The ground surface was kept parallel with the top surface of the rocker. Extra consideration has to be given to the oiling channel in the rocker arm. |
|