Exaktaphile Samba Member
Joined: October 01, 2010 Photos: 241
|
Butt Welding |
Posted: Fri Jun 08, 2018 1:11 am Views: 106
Rating: Not rated
|
|
I bought some of the HF butt weld clamps and they set a pretty wide gap. I took the center dividers out of the clamps and filed them down so they're the thickness of my wire and they worked great. .028" is pretty thin but these clamps are cheap so buy some extras in case you mess some up.
If you taper the end of the dividers so they're thinner than the weld gap, you'll have less problems with clamps getting stuck in the joint. This is one of Danny Gabbard's fender panels. 1957 lowlight Ghia |
|