Hello! Log in or Register   |  Help  |  Donate  |  Buy Shirts  See all banner ads | Advertise on TheSamba.com  
TheSamba.com
 
Future VW engine projects
Photo link: Forum code:
Future VW engine projects
Author Photo
Rome
Samba Member


Joined: June 02, 2004
Photos: 326
Location: Pearl River, NY
Rome is offline 

Future VW engine projects Posted: Mon Dec 10, 2018 4:22 pm     Views: 18      Rating: Not rated

Sept. 2017 I picked up 2 cases and 3 pairs of heads which I had machined at Valley VWs/The VW Store in eastern PA. Both cases had original main bearing dimensions and did not need an align-bore. Both engines were long-blocks which were either given to me, or were low-cost purchases.

-H5 case: cylinder spigots decked, 8mm case savers installed, oil galleys tapped for plugs for easy clean-out.
-1970 D case (dual-relief)- cylinder spigots opened for 90.5 cylinders, 8mm case savers.

All heads are stock 35mm intake/32mm exhaust, and have unbroken exhaust studs.
-Single port: Opened to 90.5mm bore size
-Dual port 1: Opened to 94mm bore
-Dual port 2: Opened to 90.5mm bore

Search Forums for photo
View user's profile Send private message Gallery Classifieds Share: Facebook Twitter

All times are Mountain Standard Time/Pacific Daylight Savings Time

About | Help! | Advertise | Donate | Premium Membership | Privacy/Terms of Use | Contact Us | Site Map
Copyright © 1996-2018, Everett Barnes. All Rights Reserved.
Not affiliated with or sponsored by Volkswagen of America | Forum powered by phpBB