Daddybus Samba Member
Joined: June 15, 2000 Photos: 312
|
1.5" Heaterbox |
Posted: Sat Jan 04, 2020 11:12 pm Views: 112
Rating: Not rated
|
|
I had a set of Gene Berg 1.5" high performance heaterboxes ( a 1.5" J-tube stuffed inside a heaterbox shell...no heat sink. When I ran them in the daddybus cold air would rush in and chill the bus until the motor heated up. Once the motor warmed up they produced almost enough heat to return the bus to the same temperature as I started. So 10 years ago I decides to open up the heaterboxes and add heat sinks. As the project stalled, I switched from an A-1 sidewinder header to a stainless Vintage Speed exhaust. If you run a Vintage Speed exhaust, then you know that they get quite hot. So I ordered a matching set of their stainless J-tubes and swapped it into the Berg boxes. I added some thin-walled stainless tubing to make a heat sink. BBQ paint ended the day. One down, one more to go (tomorrow's project. |
|