Amskeptic Samba Member
Joined: October 18, 2002 Photos: 64 Location: All Across The Country
|
"Bushing" |
Posted: Thu Mar 15, 2007 4:28 pm Views: 362
Rating: Not rated
|
|
I drilled the throttle levers with a bit that was slightly smaller than my new "bushings", heavily modified 16 ga spade terminals that were ground down on the bench grinder. They already have a nice "waist" to stay inside the holes on the throttle levers. I did need to bevel the ends to get them to start into the holes without too much of a fight. |
|