| jbow1076 |
Mon May 08, 2006 3:37 pm |
|
| I just replaced the master cylinder and fear wheel cylinders on my 1970 fastback. I have bled the brakes and I can't get the pedal to rise up to where it usually is. When I press on the brake, I don't get pressure till almost the floor, unless I pump it up a couple of times and then it engages sooner. It doesn't appear that I have air in the lines, but I don't feel confident in my brakes right now. Does any have any suggestion? |
|
| Notched |
Mon May 08, 2006 4:42 pm |
|
| Did you bleed all four? |
|
| Tram |
Mon May 08, 2006 4:44 pm |
|
| Rear brake adjustment too loose. Here's a test- Pull your E brake on. Is the pedal higher now? If so, adjust the rear brakes. |
|
| COFBack |
Tue May 09, 2006 5:39 am |
|
Sounds to me like you need another trip around the bleed cycle
Remember that the order you go around matters. Sorry I don't have my bentley with me but I think it is FR, FL, RL, RR
PUSH to the floor
Open
Close
RELEASE
good luck |
|
Powered by phpBB © 2001, 2005 phpBB Group
|