| 54panel |
Wed Jan 10, 2007 6:01 am |
|
In storage my front bumper has been bent backward's deveolping two crack's top and bottem each side of the middle weld
Could I ask one of you kind gents to measure your front bumper from tip to tip (mine is currently 1750mm which I know is wrong) so I can repair it correctly
Thank you |
|
| BeaterBarndoor |
Wed Jan 10, 2007 8:11 am |
|
| i come up with 62.5 inches or 1587.5mm. |
|
| 54panel |
Wed Jan 10, 2007 11:10 am |
|
Thank you for you promt reply Beaterbarndoor
I was expecting it to be smaller than the figure I had, as I need to bring the end's closer together to close the gap am I right in pressuming this is an internal measurment ? |
|
| RockStock |
Wed Jan 10, 2007 11:17 am |
|
| 1750>1587.5 |
|
| BeaterBarndoor |
Wed Jan 10, 2007 11:36 am |
|
| yes, i just assumed we would have both measured the same. i put the tape measure butt against the inside edge to one tip and extended to the other inside edge, both right at the tip |
|
| 54panel |
Wed Jan 10, 2007 12:28 pm |
|
second post nerves :oops: well spotted rockStock
pressure against both ends closes the cracks to that size thanks again BeaterBarndoor |
|
Powered by phpBB © 2001, 2005 phpBB Group
|