| hpw |
Sun Dec 30, 2007 7:38 pm |
|
Any one attempt painting the thermostat flaps, and if so any help full
hints. I'm afraid that painting will interfere with the flap operation.
I think I've seen these powder coated somewhere, but I'm not sure
Did the search and found nothing.
|
|
| Glenn |
Sun Dec 30, 2007 7:42 pm |
|
| I had mine media blasted with my tin, but was afraid that powder painting would lockup the movement. So I sprayed mine with a clear heat resistant paint by Eastwood called Diamond Clear. |
|
| hpw |
Sun Dec 30, 2007 7:54 pm |
|
Glenn wrote: I had mine media blasted with my tin, but was afraid that powder painting would lockup the movement. So I sprayed mine with a clear heat resistant paint by Eastwood called Diamond Clear.
Thanks Glen
Would you know where you can get these little grommets that fit on each
side? There isn't much left of the ones I pulled out. Are they neccesary?
[img][/img] |
|
Powered by phpBB © 2001, 2005 phpBB Group
|