| TeeSquare2000 |
Thu Jul 17, 2025 5:55 am |
|
I had a bad ball joint on my Bradley GT which has a Type 3 chassis. I decided to change all four. While changing out the ball joints, the left, top torsion arm ball joint was seized into the socket on the arm. All of the others, I had to just give it a tap with the hammer and they popped out. This one, I could not get it out. I tried cutting it out. I tried heat. I tried everything that I knew.
I finally found a set on eBay and just replaced it. Has anyone had a ball joint seize into the arm socket like this?
|
|
| Bobnotch |
Thu Jul 17, 2025 1:18 pm |
|
| Nope, but I've seen them try to rust in place before. Some oxy heat and a BFH usually knock them out. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|